Weld-On® All-Seal™ Pipe Thread Sealant, Soft-Setting, Grit-Free, Low-VOC, Beige, Pint

Schedule 40 PVC corrosion resistant pressure pipe, IPS sizes 1/8-24, is ideal for use in applications with temperatures up to and including 140 degrees F. Pressure rating (120 psi to 230 psi) varies with pipe size and temperature. It is generally resistant to most acids, bases, salts, aliphatic solutions, oxidants, and halogens. Chemical resistance data is available and should be referenced for proper material. Schedule 40 PVC pipe exhibits excellent physical properties and flammability characteristics. Typical applications include: chemical processing, plating, high-purity applications, potable water systems, water and wastewater treatment, irrigation and agriculture along with many other industrial applications involving corrosive fluid transfer. Schedule 40 pipe is not recommended for threading or grooving. If threading is required for the application, solvent-cemented male or female adapters should be utilized. If grooving is required, solvent-cemented grooved adapters are available in limited sizes.Do not test or use PVC piping for air or compressed gasses. Care should be taken to avoid ketones, chlorinated hydrocarbon, and aromatic solvents.

PVC is the most commonly used plastic material for manufacturingplastic pipe. It has a relatively high tensile strength and module ofelasticity. These features make it stronger and more rigid than mostother thermoplastics. It is also resistant to most acids, bases,salts, aliphatic solutions, oxidants and halogens. The joiningmethods for PVC are by solvent cementing, threading (Schedule 80ONLY) or flanging. PVC has been used successfully in industries suchas chemical processing, industrial planting, chilled waterdistribution, salt water, chemical drainage, irrigation systems andother industrial applications with corrosive fluid transfer. Thepressure rating systems given are for solvent-cemented systems. Whenadding valves, flanges or other components, the system must bede-rated to the rating of the lowest component: threaded fittings arerated at 50% of solvent-cement systems; flanged fittings are rated at150 psi; union fittings are rated at 235 psi. Please seemanufacturers' recommendations for other ratings. Do not test or usePVC piping for air or compressed gasses.

CTS CPVC pipe and fittings are used for hot and cold domestic water distribution. For use where the operating temperature will not exceed 180°F at 100 psi. The fittings are copper tube sized and are ideally suited for water applications due to their corrosion resistance rating. Both pipe and fittings are manufactured to exacting standards in order to give a tight reliable fit.

Chlorinated polyvinyl chloride (CPVC) is created by subjecting PVC resin to a post chlorination reaction that results in additional chlorine atoms on the base molecule. This results in a thermoplastic material similar to PVC with added advantages: a higher heat distortion temperature and improved fire performance properties at relatively low cost compared to alternative materials. As with PVC, the physical properties of CPVC can be altered considerably to provide desirable properties by compounding techniques. CPVC provides an economic solution for piping utilized in process piping, hot water, and similar service applications where operating conditions exceed the recommended temperature limits of PVC.

Weld-On® CanTote™ Carrier for use with quart and pint cans of cement and primer.

Weld-On® 845™ manual dispensing gun comes in three options. Part # 14151 is for use with 400 mL cartridges and is a plastic frame. Part # 14152 is for use with 400 mL cartridges and is a metal frame. Part # 12471 is for use with 43 mL cartridges and is a plastic frame. For use with 845™ two-component, high strength, highly viscous, low VOC reactive adhesive.

Weld-On® 811™ Mixing Tips for use with 470 mL Cartridges

Weld-On® soft seal plumbers putty is a plastic putty and fixture setting compound that will not harden, crack or crumble.